耀王邦防潮防霉腻子粉是建筑装饰材料的一种，主要成分由重钙，灰钙，水泥作为胶凝材料和一种替代胶水的天然环保纤维素醚组成。通常腻子的白度在85以上细度在330以上。腻子是来墙面修补找平的一种基材，为下一步装饰（刷油漆贴壁纸）打下良好的基础。
耀王邦环保腻子粉按照我国现行的标准：JG/T 298-2010 GB 18582-2008。
产品特点：
1、不用胶水直接兑水拌匀即可使用;
2、本品与传统的石粉加胶水批墙相比，具有不含甲醛，施工方便，轻松自如，粘结力强，不龟裂、不脱粉、表面细腻光滑;
3、绿色环保，无毒无刺激性气味，无放射性;
4、防潮防霉，时间越长越坚硬，不受气候影响。
施工要求：
1、将墙面处理平整，墙面如有油清污、粉尘或其它松胶物等，必须清除干净方可施工。
2、本品按约2份粉：1份水（先加水后加粉）拌匀，放置约10分钟后使用效果更佳。
3、施工操作与传统的石粉加胶水批墙施工基本相同，一般按打底罩面各一遍，不宜刮得太厚，1-2mm为宜，**遍打底时，要求平整，又要尽量刮薄，待底层完全干后再罩面，效果更好。罩面压平后约七八成干表面浆不粘手时用刮刀抛光2-3次，便出效果，不能等浆干后才抛光，否则会影响效果。
注意事项：
1、本品不能随意添加辅助材料（如胶水，白乳胶，熟胶粉等，如添加后造成质量问题，本厂不负责任。）
2、本品不能直接批在石膏板、硅酸板、夹板、水泥板等非灰沙墙面上。
3、本品存放在阴凉干燥处，保质期为一年，超过保质期后如无结块、变质、可继续使用，不影响质量。
4、室内旧墙翻新，应先在墙面上做小块实验，若有返黄现象，不宜使用。
Yao Wang State moisture-proof mildew putty powder is a kind of building decoration material, the main composition by heavy calcium, gray calcium, cement as a cementitious material and a natural environmental protection cellulose ether instead of glue. Usually the whiteness of putty is above 85 and fineness is above 330. Putty is a kind of base material used for metope repair and leveling, which is a good foundation for the next step of decoration (brush paint and stick wallpaper).
Yaowang environmental protection putty powder in accordance with the current standard of our country: JG/T 298-2010 GB 18582-2008.
Product features:
1, without glue directly mixed with water can be used;
2. Compared with the traditional stone powder and glue batch wall, this product has no formaldehyde, convenient construction, easy, strong adhesion, no cracking, no powder removal, fine and smooth surface;
3, green environmental protection, non-toxic non-irritating odor, non-radioactive;
4, moisture-proof, the longer the harder, not affected by climate.
Construction requirements:
1. Smooth the wall. If there is oil, dust or other loose glue on the wall, it must be cleaned before construction.
2, this product according to about 2 parts powder: 1 part water (first add water and then add powder) mix well, placed for about 10 minutes after the use of better effect.
3, the construction operation and the traditional stone powder and glue batch wall construction is basically the same, generally according to the bottom cover surface each time, should
not be scraped too thick, 1-2mm is appropriate, the first time, the requirements are smooth, and should be scraped as thin as possible, until the bottom is completely dry and then the cover surface, the effect is better. When the dry surface pulp is not sticky to the hand, it is polished 2-3 times with a scraper, and the effect is not polished after the pulp is dry, otherwise the effect will be affected.
Notes:
1, this product can not arbitrarily add auxiliary materials (such as glue, white latex, cooked rubber powder, etc., such as added after the quality problems, the factory is not responsible.)
2, this product can not be directly batch on gypsum board, silicate board, plywood, cement board and other non-grey sand wall.
3, this product is stored in a cool and dry place, the shelf life is one year, after the shelf life, such as no caking, deterioration, can continue to use, does not affect the quality.
4, indoor old wall renovation, should first do a small piece of experiment on the wall, if there is a yellow phenomenon, should not be used.
